VK 112 Paving Breaker-30lb

Paving Breaker – VK 0112 ( 30 lb )

The VK 112 is a 13.5 kg pneumatic paving breaker, technically equivalent to the Chicago Pneumatic CP 112. It is the lightest breaker Vikay builds, delivering 1,620 blows per minute on 23 l/s of air at 6 bar, which suits light demolition of floors, pavement, frozen ground and masonry walls. The 25 x 108 mm shank and four bolt back head make it a common choice for bridge deck work where machine weight is restricted.

Features 

• Alloy steel forgings – for excellent durability 

• Four-bolt back head withstands rugged use 

• Integral oiler which provides continuous lubrication

• In addition to the standard units, there are also silence versions (S models)* and versions with extra vibration dampening (SVR models)*.

Technical Data

# Technically equivalent to CP 112 Pneumatic Breaker

VK 112 Paving Breaker FAQs

Can the VK 112 replace a CP 112?

Yes. Vikay manufactures the VK 112 in India as the technical equivalent of the Chicago Pneumatic CP 112. A 42 mm piston on a 93 mm stroke gives 1,620 blows a minute at 13.5 kg on 23 l/s of air at 6 bar. It takes the same 25 x 108 mm shank, so moil points, chisels and asphalt cutters already on site will fit.

Will Vikay parts fit my CP 112?

Yes. Vikay manufactures the VK 112, which is technically equivalent to the Chicago Pneumatic CP 112, and the replacement parts alongside it. The same parts serve both, so a machine already in service can be kept running on them. The CP 112 Chicago Pneumatic Paving Breaker Parts page carries the full listing, part number by part number.

Which Vikay paving breaker do I need?

This page is the VK 112 at 13.5 kg, the lightest in the range. Vikay manufactures breakers from 13.5 kg to 42 kg and the weight is the job: 13.5 kg for light construction and plant maintenance, 20 to 30 kg for general breaking, asphalt and pavement, 36 kg and above for reinforced concrete, frozen ground and thick pavement. The lightest machine that will do the work is usually the right one, because a heavier breaker breaks faster but tires the operator sooner. Silenced versions are manufactured alongside most models where noise is regulated.

See also: VK 112S, VK 1210, VK 1230

Will my compressor run the VK 112?

The VK 112 needs 23 l/s at 6 bar (49 cfm at 87 psi), delivered continuously. The inlet is 19 mm, so run at least that hose bore: anything narrower throttles the machine before the compressor does. At 1,620 blows a minute the draw is constant rather than intermittent, so the compressor has to hold the figure under load, not merely reach it.

Will my existing moil points, chisels and asphalt cutters fit the VK 112?

The VK 112 takes a 25 x 108 mm shank (1" X 4 1/4"), so any moil point cut to that shank fits, whatever machine it came off. If the shank does not match, the tools are the cheaper thing to change.

See also: Vikay moil points and chisels